Black decker air conditioner manual

This Model number easy-to-use manual will guide you in getting the best use of your air conditioner. Serial number Remember to record the model and serial numbers. Immediately rinse your eyes with clean tap water and then consult a physician immediately.

It is recommended that a separate circuit serving only the product be provided. The product is equipped with a 3-wire cord having a 3-prong grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded.

Incorrect operation due to ignoring of instructions may cause harm or damage. Plug in the Air Conditioner. Prior to installation, remove plastic locking pin, adjust to desired length and use provided metal locking screws to secure.

Connect hose inlet to one end of air exhaust hose. Push hose inlet over the end of the hose, push in slightly and then start threading it on in a counter clockwise 2.

Your model may or may not have all the features. To set described for the cool mode. The remote control between the remote control and the receiver. You should therefore refer to the instructions in the chapter Operating from the Fan, Heat and the fan speed. The following section describes the additional functions corresponding to the controls on the bottom part of the remote control. While this function is selected, it is not possible to set the temperature or change fan speed.

Thus the tank may still require emptying in HEAT mode. NOTE: As a safety measure to positively prevent water spillage the air not restart until the tank has been drained. Wait for a few minutes then unplug from the electrical outlet. If it is not, remove the plug from the outlet, wait 10 seconds and plug it in again securely.

B Check for a blown circuit fuse or a tripped main circuit breaker. If the air conditioner still does not work properly, contact W Appliance Co. Customers must never troubleshoot internal components. It must be plugged into a wall receptacle that is properly installed and grounded. Incorrect operation due to ignoring of instructions may cause harm or damage.

To test your supply cord follow these steps: 1. Plug in the Air Conditioner. Your model may or may not have all the features. To set described for the cool mode. You should therefore refer to the instructions in the chapter Operating from the Control Panel to turn the appliance on and select the operating mode Cool, Dry, Fan and the fan speed.

While this function is selected, it is not possible to set the temperature or change fan speed. Wait for a few minutes then unplug from the electrical outlet. If it is not, remove the plug from the outlet, wait 10 seconds and plug it in again securely. If the air conditioner still does not work properly, contact W Appliance Co. Customers must never troubleshoot internal components. Food loss for loss due to product failure or delay in service, repair or and all questions about this product should be replacement.

Page 23 Page All rights reserved. Product in this box may differ slightly from that pictured. Does not affect function. Not all accessories shown in photography are included in this package. This manual is also suitable for: Bpact10 series. Print page 1 Print document 24 pages. Rename the bookmark.